Drolet Adirondack Instrukcja Właściciela

Printed in Canada 45061A 14-12-2011 OWNER`S MANUAL ELDORADO, ADIRONDACK, JURASSIEN, CELTIC AND SAVANNAH US ENVIRONMENTAL PROTECTION AGENCY

10 ASH LIP INSTALLATION FOR JURASSIEN MODEL Your Jurassien can be equipped with an ash lip. Place it as shown on detail below and secure it in place

11 THE BENEFITS OF INSTALLING A BLOWER A blower can be installed at the back of your DROLET stove (included on Eldorado.) This option is necessary if

12 INSTALLATION SAFETY NOTICE  IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATIO

13 CLEARANCES TO COMBUSTIBLES AND FLOOR PROTECTOR To install your appliance correctly, it is extremely important to respect all clearances to any com

14 Figure 2: Clearances to combustibles and floor protector

15 FLOOR PROTECTOR If the stove is to be installed on top of a combustible floor, it must be guarded by a non combustible material as shown on figure

16 REDUCED CLEARANCES USING SHIELDING You may decrease the clearances by installing heat radiation shields between the walls or the ceiling and the

17 Graphic 1 A- Minimum clearance required between the appliance and an unshielded combustible ceiling. B- 20 in. (500 mm) minimum; C- 1 in. (2

18 Graphic 2 A- 1 in.(25 mm) minimum; 1- Combustible wall; 2- Non-combustible spacers; 3- 0.024’’ (0.61 mm) sheet metal. Graphic 3 A- 1 in. (2

19 Graphic 5 A- 1 in. (25 mm) minimum; 1- Combustible wall; 2- Non-combustible spacers; 3- Brick. Graphique 6 A- 1 in. (25 mm) minimum; 1-

2 INTRODUCTION SBI INC., one of the most important wood stove and fireplace manufacturers in Canada, congratulates you on your purchase and wishes t

20 CHIMNEY Your wood stove may be hooked up with a factory built or masonry chimney. If you are using a factory built chimney, it must comply with U

21 CHIMNEY CONNECTOR Your chimney connector (commonly called  stove pipe) and chimney must havethe same diameter as thestove’s exhau

22 FIGURE 2.3 (B) Minimum Slope  Theassemblyshouldbeasshortanddirectaspossiblebetweenthestoveandchimney(Seefigure2.4 (A)). Th

23 DRAFT Your E.P.A Drolet stove’s performance will be optimised if it is installed with a chimney (flue) system that provides an adequate draft. T

24 MASONRY CHIMNEY: Clay liner Thimble Clean out door

25 FACTORY BUILT THIMBLE:

26 BRICK THIMBLE:

27 OUTSIDE COMBUSTION AIR Your DROLET stove is approved to be installed with an outside air intake which is necessary for a mobile home. This type o

28 WOOD STOVE UTILISATION Your heating unit was designed to burn wood only; no other materials should be burnt. Wastes and other flammable materials

29 Smaller pieces of wood will dry faster. All logs exceeding 6" in diameter should be split. The wood should not be stored directly on the grou

3 TABLE OF CONTENTS INTRODUCTION ... 2

30 HEATING Controlled combustion is the most efficient technique for wood heating because it enables you to select the type of combustion you want fo

31 RELOADING Once you have obtained a good bed of embers, you should reload the unit. In order to do so, open the air controls to maximum a few secon

32 ASH DISPOSAL Ashes should be removed from the stove every few days or when ashes get to 2 to 3 inches deep. Always empty the stove when it is cold

33 MAINTENANCE Your Drolet stove is a high efficiency stove and therefore requires little maintenance. It is important to perform a visual inspection

34 DROLET LIMITED LIFETIME WARRANTY The warranty of the manufacturer extends only to the original consumer purchaser and is not transferable. This

4 TECHNICAL SPECIFICATIONS Combustible: Wood Recommended Surface 500 to 1 500 ft2 (47 to 140 m2) Heating Capacity*: E.P.A: Seasoned cord wood:44 00

5 *Why is the BTU indicated on the EPA label different than the one advertised? You will notice a difference between the BTU output indicated on the

6 TIPS ON WOOD HEATING Wood is a renewable energy. It is also a very clean heat source when used with appliances that are certified by the U.S. Envir

7 ASSEMBLY PEDESTAL AND PANELS Pedestal Base Installation: 1. Slide the front part of the pedestal base around the pedestal and fix the rear part w

8 LEGS AND ASH PAN Ash Lip Installation: 1. Just clip the ash lip into position, centred just below the door. 2. Slide the ash pan in position.

9 DOOR ADJUSTMENT In order for your stove to operate properly, the door should be adjusted periodically to provide an air tight fit. To adjust:  R