
READ AND KEEP THIS MANUAL FOR REFERENCE 45109A 2010-09-22 INSTRUCTIONS & OPERATIONS MANUAL DROLET COMPAK EPA EXEMPT US ENVIRONMENTAL PROTEC
9 TYPICAL INSTALLATIONS FACTORY BUILT CHIMNEY: ROOF FLASHING18" CLEARANCEWALL SUPPORTWALL RADIATION SHIELDRAIN CAP Wall installation CEIL
10 MASONRY CHIMNEY: Clay liner Thimble Clean out door
11 FACTORY BUILT THIMBLE:
12 BRICK THIMBLE:
13 WOOD STOVE UTILISATION Your heating unit was designed to burn wood only; no other materials should be burnt. Wastes and other flammable material
14 Smaller pieces of wood will dry faster. All logs exceeding 6" in diameter should be split. The wood should not be stored directly on the gr
15 ASH DISPOSAL Ashes should be removed from the stove every few days or when ashes get to 2 to 3 inches deep. Always empty the stove whe
16 AIR CIRCULATION SYSTEM In order to improve air circulation in the room where the wood stove is installed, certain options are available for specif
17 WARNING: NEVERS OPERATE THE STOVE WITHOUT A GASKET OR WITH A BROKEN ONE. DAMAGE TO THE STOVE OR EVEN HOUSE FIRE MAY RESULT PAINT Only cle
18 DROLET LIMITED LIFETIME WARRANTY The warranty of the manufacturer extends only to the original consumer purchaser and is not transferable. T
1 TABLE OF CONTENTS INTRODUCTION ...
2 INTRODUCTION STOVE BUILDER INTERNATIONAL INC., one of the most important wood stove and fireplace manufacturers in Canada, congratul
3 ASSEMBLY Legs installation: Position the stove on its back and screw the legs in place with 8 screws, 8 bolts, and 8 washers; Ash
4 Cast iron flue collar installation: 1. Peel off the tape from the back of the gasket and attach the gasket to the rope groove at the back of t
5 INSTALLATION SAFETY NOTICE IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATIO
6 CLEARANCES FROM COMBUSTIBLES It is of outmost importance that the clearances to combustible materials be scrupulously respected upon installation o
7 CHIMNEY Your wood stove may be hooked up with a factory built or masonry chimney. If you are using a factory built chimney, it must comply with UL
8 CHIMNEY CONNECTOR (STOVE PIPE) The stove pipe must be made of aluminized or cold roll steel with a minimum thickness of 0.021" or 0.53 mm. It
Komentarze do niniejszej Instrukcji